Router Quick Start Guide

6
Secure the Spacers
Install the Hardware
53425
A
B
C
Step 1 Loosen the 10-32 x 5/8-inch LG Phillips
pan-head screw at the end of the ledge of
the right-side bracket. This screw is the
anchor for the spanner bar.
Step 2 Remove the tape that secures the spanner
bar on the left bracket, and swing the bar
down(see A) over the anchor screw on the
opposite bracket (see B).
Step 3 If the spanner bar does not reach the
opposite bracket, loosen the pan-head
screws to allow more play between the
brackets, and adjust brackets as needed.
Step 4 RepeatStep 1 through Step 3 tofasten the
remainingspannerbartoitsanchorscrew.
(See C.)
Step 5 Push the brackets as far apart as possible
before tightening the screws.
Step 6 Use a Number 2 Phillips screwdriver to
tighten the six pan-head screws that
secure the brackets to the rack-mounting
posts, and the two anchor screws that
secure the spanner bars.
Step 7 Adjust the brackets if the distance
between them is less than 17.5 inches
(44.45 cm).