Router Quick Start Guide

3
Install the Router on a Bench or Tabletop
Install the Hardware
POWER
A
POWER
B
H3118
Note To rack-mount the router, refer to the
“Rack-Mount the Router (Recommended)” section
on page 4.
Caution Two people are required to
perform this step. Avoid sudden twists or
moves to prevent injury.
Step 1 With a person positioned at either side of
the chassis, grasp the bottom edge of the
chassis with one hand near the front and
the other near the back. Slowly lift the
chassis in unison. Place the chassis on a
bench or tabletop where the air intake
vent on the front of the chassis is not
drawing in exhaust air from other
equipment.
Warning When lifting the router, do not
lift by grasping the handle of the blower
module, nor should you grasp the air intake
grill.
Step 2 Ensure that you have at least 2 or 3 feet
(0.6to.09m)ofclearancearoundtherear
ofthechassistoinstallpowersupplies and
perform maintenance on the chassis.
Step 3 Proceed to the “Install Interface
Processors, Fillers, VIPs, or RSPs” section
on page 9.