Router Quick Start Guide

13
Connect DC-Input Power Supply
Install the Hardware
m
ove
ly
0
I
OK
OK
DC
FAN
O
Power leads
attached to
terminal block
(+) Positive
(–) Negative
( ) Ground
C
a
ins
t
s
DC-input power s
u
with the terminal
b
cover remove
d
Conduit
bracket
Warning The system power switch on the
power supply should be off.
Step 1 Use a screwdriver to loosen and remove
the terminal block cover screws.
Step 2 Lift and remove the terminal block cover.
Step 3 Route the DC-input power cable from the
powersourcethrough the conduit bracket
on the power supply. Allow sufficient
slack in the cable.
Step 4 Attach and tighten the conduit to the
conduit bracket.
Note The proper wiring sequence is ground to
ground, positive to positive (line to L), negative to
negative (neutral to N). The ground wire should
always be connected first and disconnected last.