Router Quick Start Guide

12
Connect AC-Input Power Supply
Install the Hardware
53486
Captive screws
0
I
AC
OK
FAN
OK
OUTPUT
FAIL
0
I
AC
OK
FAN
OK
OUTPUT
FAIL
POWER
B
Cable-retention clip
Warning The system power switch on the
power supply should be off.
Step 1 For AC-input power supplies, push the
cable retention clip away from the power
receptacle and plug in the power cable.
Step 2 Push the cable retention clip until it snaps
into place around the cable connector.
Step 3 Reconnect the power cable at the power
source, remove the tape on the breaker
switch. Do not turn on the breaker or
power to the power supply.
Note A power supply blank must remain in any
empty power supply bay.
Step 4 Repeat Step 1 through Step 3 for the
second power supply, if present.
Note Do not mix AC-input and DC-input power
supplies in the same chassis.