Network Router User Manual

Chapter 7 Scenario: Remote-Access VPN Configuration
Implementing the Remote-Access Scenario
7-8
Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
78-17372-01
Step 2 When you have finished adding new users, click Next to continue.
Configure Address Pools
For remote clients to gain access to your network, you must configure a pool of
IP addresses that can be assigned to remote VPN clients as they are successfully
connected. In this scenario, the pool is configured to use the range of IP addresses
209.165.201.1 to 209.166.201.20.
In Step 6 of the VPN Wizard, perform the following steps:
Step 1 From the drop-down list, enter a pool name or click a preconfigured pool.
Step 2 Enter the start of the range of IP addresses to be used in the pool.
Step 3 Enter the end of the range of IP addresses to be used in the pool.