Network Router User Manual

5/26/05 Adding Cisco 1000 Series Lightweight Access Points to Floor Plan and Open
Area Maps
OL-7426-03
Adding Cisco 1000 Series Lightweight Access Points to Floor Plan and Outdoor
Area MapsAdding Cisco 1000 Series Lightweight Access Points to Floor Plan and Open Area Maps
This procedure assumes that you have added the Floor Plan and/or Outdoor Area maps as described in
Adding Floor Plans to a Campus Building
, Adding Floor Plans to a Standalone Building and Adding an
Outdoor Area to a Campus. This procedure also assumes that you have added Cisco Wireless LAN
Controllers to the Cisco WCS database as described in Adding a Cisco Wireless LAN Controller to Cisco
WCS before continuing.
After you have added the .FPE and/or .PNG, .JPG, or .GIF format Floor Plan and Outdoor Area
(Coverage Area) maps and Cisco Wireless LAN Controllers to the Cisco WCS database, you can position
Cisco 1000 Series lightweight access point icons on the Cisco WCS maps to show where they are
installed in the Buildings.
Add access points to the Coverage Area maps as follows:
• Select the Monitor Tab.
• Click Network to have Cisco WCS display the Network Summary page.
• In the Network Summary page, click the desired Floor Plan or Outdoor Area map.