Network Router User Manual

5/26/05 Adding a Building to a Campus
OL-7426-03
• Ensure that the graphic has been added correctly by clicking the new Campus Name to have
the Cisco WCS User Interface display the Maps > <Campus Name> page as shown in the
following figure.
• Repeat this section for any remaining Campuses.
When you have completed this section, continue with Adding an Outdoor Area to a Campus
or Adding a
Standalone Building to the Cisco WCS Database.
Adding a Building to a CampusAdding a Building to a Campus
You can add Buildings to the Cisco WCS database whether or not you have added maps or Campuses as
described in Adding a Campus Map to the Cisco WCS Database.
To add a Building to the Cisco WCS database without associating it with a Campus, continue with
Adding a Standalone Building to the Cisco WCS Database
. To add an Outdoor Area to a Campus in the
Cisco WCS database, continue with Adding an Outdoor Area to a Campus
. Otherwise, add a Building to
a Campus in the Cisco WCS database by performing the following steps:
• Select the Monitor Tab.
• Click Maps to have Cisco WCS display the Maps page.
• In the Maps Page, select the desired Campus.
The Cisco WCS User Interface displays the Maps > <Campus Name> page.