Network Router User Manual

5/26/05 Configuring System Parameters
OL-7426-03
- Distribution System physical port (1000BASE-T, 1000BASE-SX, or 10/100BASE-T).
Note that 1000BASE-SX SFP modules provide a 1000 Mbps wired connection to a
network through an 850nM (SX) fiber-optic link using an LC physical connector.
1000BASE-LX SFP modules provide a 1000 Mbps wired connection to a network
through a 1300nM (LX/LH) fiber-optic link using an LC physical connector. 1000BASE-T
SFP modules provide a 1000 Mbps wired connection to a network through a copper link
using an RJ-45 physical connector.
- Distribution System port VLAN assignment (optional).
- Distribution System port Web and Secure Web mode settings, enabled or disabled.
- Distribution System port Spanning Tree Protocol: enabled/disabled, 802.1D/fast/off
mode per port, path cost per port, priority per port, bridge priority, forward delay, hello
time, maximum age.
WLAN Parameters
- WLAN Configuration: VLAN assignments, Layer 2 Security settings, Layer 3 Security
settings, QoS assignments.
Mobility Parameters
- Mobility Settings: Mobility Group Name (optional).
RADIUS Parameters
- RADIUS Settings.
SNMP Parameters
- SNMP Settings.
Other Parameters
- Other Port and Parameter Settings: Service port, Radio Resource Management (RRM),
Serial/CLI console port, 802.3x Flow Control, and System Logging.
Other Actions
- Assemble all files that may need uploading or downloading to the Cisco Wireless LAN
Controller, including the latest OS code.
Continue with Configuring System Parameters
.
Configuring System ParametersConfiguring System Parameters
The Cisco Wireless LAN Controller requires a few basic system parameters to communicate with other
network devices. Perform the following to set these parameters:
Time and DateTime and Date
• Use the show time command to view the Cisco Wireless LAN Controller time and date.
• If necessary, set the Cisco Wireless LAN Controller time and date by entering:
>config time MM/DD/YY HH:MM:SS
• Use the show time command to verify that the Cisco Wireless LAN Controller has stored your
input. Continue with the next parameter.