User's Manual

13-16
User Guide for Cisco Secure Access Control System 5.3
OL-24201-01
Chapter 13 Managing Reports
Working with Catalog Reports
Failure Reason Enter a failure reason name or click Select to enter a valid failure reason name on which to run your
report.
Protocol Use the drop down list box to select which protocol on which you want to run your report. Valid options
are:
• RADIUS
• TACACS+
Authentication
Status
Use the drop down list box to select which authentication status on which you want to run your report.
Valid options are:
• Pass Or Fail
• Pass
• Fail
Radius Audit
Session ID
Enter the RADIUS audit session identification name on which you want to run a report.
ACS Session ID Enter the ACS session identification name on which you want to run a report.
Severity Use the drop down list box to select the severity level on which you want to run a report. This setting
captures the indicated severity level and those that are higher within the threshold. Valid options are:
• Fatal
• Error
• Warning
• Info
• Debug
End Point IP
Address
Enter the end point IP address on which you want to run a report.
Command
Accounting Only
Check the check box to enable your report to run for command accounting.
Top Use the drop down list box to select the number of top (most frequent) authentications by access
service on which you want to run your report. Valid options are:
• 10
• 50
• 100
• 500
• 1000
• All
By Use the drop down list box to select the type of authentications on which you want to run your report.
Valid options are:
• Passed Authentications
• Failed Authentications
• Total Authentications
Table 13-5 <report_name> Page (continued)
Option Description