Network Router User Manual
Table Of Contents
- Router Platform User Interface Reference
- NAT Policy Page
- Router Interfaces Page
- Advanced Interface Settings Page
- AIM-IPS Interface Settings Page
- Dialer Policy Page
- ADSL Policy Page
- SHDSL Policy Page
- PVC Policy Page
- PPP/MLP Policy Page
- AAA Policy Page
- Accounts and Credential s Policy Page
- Bridging Policy Page
- Clock Policy Page
- CPU Policy Page
- HTTP Policy Page
- Console Policy Page
- VTY Policy Page
- Secure Shell Policy Page
- SNMP Policy Page
- DNS Policy Page
- Hostname Policy Page
- Memory Policy Page
- Secure Device Provisioning Policy Page
- DHCP Policy Page
- NTP Policy Page
- 802.1x Policy Page
- Network Admission Control Policy Page
- Logging Setup Policy Page
- Syslog Servers Policy Page
- Quality of Service Policy Page
- BGP Routing Policy Page
- EIGRP Routing Policy Page
- OSPF Interface Policy Page
- OSPF Process Policy Page
- RIP Routing Policy Page
- Static Routing Policy Page
K-73
User Guide for Cisco Security Manager 3.2
OL-16066-01
Appendix K Router Platform User Interface Reference
PVC Policy Page
PVC Advanced Settings Dialog Box—OAM-PVC Tab
Use the OAM-PVC tab of the PVC Advanced Settings dialog box to enable
loopback cells and connectivity checks (CCs) on the PVC. These functions test
the connectivity of the virtual connection.
For more information, see Defining OAM Management on ATM PVCs,
page 15-56.
Note Use the OAM tab to define additional settings related to the settings on this tab.
See PVC Advanced Settings Dialog Box—OAM Tab, page K-70.
Navigation Path
Go to the PVC Advanced Settings Dialog Box, page K-69, then click the
OAM-PVC tab.
End-to-End Continuity Check settings
Enable End-to-End
Continuity Check
When selected, OAM F5 continuity check (CC) activation and deactivation
requests are sent to a device at the other end of the PVC.
When deselected, segment CC activation and deactivation requests are
disabled.
Note If Configure Continuity Check is deselected in the OAM-PVC tab,
these settings are saved in the device configuration but are not
applied.
Activation Count The maximum number of times that the activation request is sent before the
receipt of an acknowledgement. Valid values range from 3 to 600. The
default is 3.
Deactivation Count The maximum number of times that the deactivation request is sent before
the receipt of an acknowledgement. Valid values range from 3 to 600. The
default is 3.
Retry Frequency The interval between activation/deactivation retries, in seconds. The default
is 30 seconds.
Table K-31 PVC Advanced Settings Dialog Box—OAM Tab (Continued)