Network Router User Manual
Table Of Contents
- Router Platform User Interface Reference
- NAT Policy Page
- Router Interfaces Page
- Advanced Interface Settings Page
- AIM-IPS Interface Settings Page
- Dialer Policy Page
- ADSL Policy Page
- SHDSL Policy Page
- PVC Policy Page
- PPP/MLP Policy Page
- AAA Policy Page
- Accounts and Credential s Policy Page
- Bridging Policy Page
- Clock Policy Page
- CPU Policy Page
- HTTP Policy Page
- Console Policy Page
- VTY Policy Page
- Secure Shell Policy Page
- SNMP Policy Page
- DNS Policy Page
- Hostname Policy Page
- Memory Policy Page
- Secure Device Provisioning Policy Page
- DHCP Policy Page
- NTP Policy Page
- 802.1x Policy Page
- Network Admission Control Policy Page
- Logging Setup Policy Page
- Syslog Servers Policy Page
- Quality of Service Policy Page
- BGP Routing Policy Page
- EIGRP Routing Policy Page
- OSPF Interface Policy Page
- OSPF Process Policy Page
- RIP Routing Policy Page
- Static Routing Policy Page
K-51
User Guide for Cisco Security Manager 3.2
OL-16066-01
Appendix K Router Platform User Interface Reference
SHDSL Policy Page
Line Mode The line mode used by the controller:
• auto—The controller operates in the same mode as the other line
termination (2-wire line 0, 2-wire line 1, or 4-wire enhanced). This is the
default for CPE line termination.
• 2-wire—The controller operates in two-wire mode. This is the default
for CO line termination.
• 4-wire—The controller operates in four-wire mode.
Note You can select Auto only when you configure the controller as the
CPE.
Line Applies only when the Line Mode is defined as 2-wire.
The pair of wires to use:
• line-zero—RJ-11 pin 1 and pin 2. This is the default for CO line
termination.
• line-one—RJ-11 pin 3 and pin 4.
Exchange Handshake Applies only when the Line Mode is defined as 4-wire.
The type of handshake mode to use:
• [blank]—The handshake mode is not specified. (When deployed, the
enhanced option is used.) This is the default.
• enhanced—Exchanges handshake status on both wire pairs.
• standard—Exchanges handshake status on the master wire pair only.
Table K-22 SHDSL Dialog Box (Continued)