Network Router User Manual

Octal-Port DMT ATU-C Line Card
Prerequisites
6
Cisco IOS Release 12.1(6)DA
Prerequisites
To use the 8xDMT feature, you must have one of the following DSLAMs with the 8xDMT line card, and
IOS 12.1(6) or above installed:
• Cisco 6015
• Cisco 6160
• Cisco 6260
Configuration Tasks
See the following sections for configuration tasks for the 8xDMT feature. Each task in the list indicates
if the task is optional or required.
• Preprovisioning the 8xDMT Line Card, page 6 (optional)
• Creating and Associating a DSL Profile with Each Port, page 7 (required)
• Modifying the DSL Profile, page 7 (optional)
Preprovisioning the 8xDMT Line Card
Starting at the global configuration prompt, use the following commands to preprovision a slot for use
with the 8xDMT line card:
Tips After you have completed these steps, insert the 8xDMT line card to activate the card with your
preprovisioned configuration.
Verifying the Preprovisioned Slot
Use the show running-configuration command to verify that you preprovisioned the slot correctly.
Command Purpose
Step 1
DSLAM(config)# slot 1 ATUC-1-DMT8
This command associates the 8xDMT line card with
the specified slot.
Step 2
DSLAM(config)# dsl-profile 8xDMT
Creates and names the DSL profile, 8xDMT in
this example.
Step 3
DSLAM(config-dsl-prof)# exit
Return to the global configuration prompt.
Step 4
DSLAM(config)# interface atm1/1
Enter interface configuration mode on the port
where you will associate the 8xDMT DSL profile.
Repeat this process on each port that you wish to
associate with a DSL profile.
Step 5
DSLAM(config-if)# dsl profile 8xDMT
Associates the DSL profile named 8xDMT with
atm interface 1/1.
Step 6
DSLAM(config-if)# exit
Return to the global configuration prompt.