Network Processing Engine Installation and Configuration

9-30
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 9 Removing and Installing the NPE or NSE
Removing and Replacing the NPE or NSE
Figure 9-22 Connecting DC-Input Power to a Cisco uBR7246VXR Router
Step 3 If necessary, use a wire stripper to strip approximately 0.55 inch (14 mm) from the –V, +V, and ground
leads.
Note The ground lead for the Cisco uBR7246VXR router DC-input power supply consists of a two-hole
grounding lug that connects to an M5 grounding receptacle; you do not need to strip this ground lead.
Figure 9-23 Stripping the DC-Input Lines
1 Power switch 6 –V lead
2 Power receptacle 7 M4 studs
3 Captive installation screw 8 +V lead
4 M5 grounding receptacles 9 Handle
5 M5 grounding lug
66407
3
8
1
2
9
7
5
6
4
1 0.55 in. (14 mm)
57019
1