user manual

18-83
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F372 Edit the OSI Router Configuration
Note Changing a routing mode should be carefully considered. Additional information about OSI
systems and protocols are provided in the “Management Network Connectivity” chapter of the
Cisco ONS 15600 SDH Reference Manual.
Step 4 Although Cisco does not recommend changing the Link State Protocol Data Unit (LSP) buffer sizes, you
can adjust the buffers in the following fields:
• L1 LSP Buffer Size—Adjusts the Level 1 link state PDU buffer size.
• L2 LSP Buffer Size—Adjusts the Level 2 link state PDU buffer size.
Step 5 Return to your originating procedure (NTP).
DLP-F372 Edit the OSI Router Configuration
Step 1 Click the Provisioning > OSI > Routers > Setup tabs.
Step 2 Chose the router you want provision and click Edit.
Step 3 In the OSI Router Editor dialog box:
a. Check or uncheck the Enabled box to enable or disable the router.
Note Router 1 must be enabled before you can enable Routers 2 through 12.
b. For enabled routers, edit the primary area address, if needed. The address can be between
8 and 24 alphanumeric characters in length.
c. If you want to add or edit an area address to the primary area, enter the address at the bottom of the
Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length.
Click Add.
d. Click OK.
Step 4 Return to your originating procedure (NTP).
Purpose This task allows you to edit the OSI router configuration, including
enabling and disabling OSI routers, editing the primary area address, and
creating or editing additional area addresses.
Tools/Equipment None
Prerequisite procedures DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher