user manual
18-58
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F351 Roll the Source or Destination of One Optical Circuit
Figure 18-13 Selecting a Path
Step 8 Click Next.
Step 9 In the Select New End Point area, choose the Slot, Port, and VC3 or VC4 from the drop-down lists to
select the Roll To facility (Figure 18-14).
Figure 18-14 Selecting a New Endpoint
Step 10
Click Finish. On the Circuits tab, the circuit status for the Roll From port changes from DISCOVERED
to ROLL_PENDING.