user manual

18-57
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F351 Roll the Source or Destination of One Optical Circuit
Step 4 From the Tools menu, choose Circuits > Roll Circuit.
Step 5 In the Roll Attributes area, complete the following (Figure 18-12):
a. From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll (required for a
1-way source roll) or Manual to create a manual roll (required for a 1-way destination roll).
b. From the Circuit Roll Type drop-down list, choose Single to indicate that you want to roll one
cross-connect on the chosen circuit.
Figure 18-12 Selecting Single Roll Attributes
Step 6
Click Next.
Step 7 In the Pivot/Fixed Point 1 window, click the square in the graphic image that represents the facility that
you want to keep (Figure 18-13).
This facility is the fixed location in the cross-connect involved in the roll process. The identifier appears
in the text box below the graphic image. The facility that is not selected is the Roll From path. The
Roll From path is deleted after the roll is completed.