user manual

18-49
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F346 Create an MS-SPRing on a Single Node
Tip To move an icon to a new location, for example, to see MS-SPRing channel (port) information
more clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl,
drag the icon to a new location.
Step 4 Right-click the MS-SPRing node channel (port) where the manual ring switch was applied and choose
Set West Protection Operation or Set East Protection Operation, as applicable.
Step 5 In the dialog box, choose CLEAR from the drop-down list. Click OK.
Step 6 Click Ye s in the Confirm MS-SPRing Operation dialog box. The letter “M” is removed from the channel
(port) and the span turns green on the network view map.
Step 7 From the File menu, choose Close.
Step 8 Return to your originating procedure (NTP).
DLP-F346 Create an MS-SPRing on a Single Node
Step 1 In node view, click the Provisioning > MS-SPRing tabs.
Step 2 In the Suggestion dialog box, click OK.
Step 3 In the Create MS-SPRing dialog box, enter the MS-SPRing information:
• Ring Type—Enter the ring type (2 Fiber) of the MS-SPRing.
• Ring Name—Enter the MS-SPRing name. If the node is being added to an MS-SPRing, use the
MS-SPRing ring name.
• Node ID—Enter the node ID. If the node is being added to an MS-SPRing, use an ID that is not used
by other MS-SPRing nodes in that ring.
• Ring Reversion—Enter the ring reversion time of the existing MS-SPRing.
• West Line—Enter the slot on the node that will connect to the existing MS-SPRing through the
node’s west line (port).
• East Line—Enter the slot on the node that will connect to the existing MS-SPRing through the
node’s east line (port).
Step 4 Click OK.
Purpose This task creates an MS-SPRing on a single node. Use this task to add a
node to an existing MS-SPRing or to delete and then recreate an
MS-SPRing temporarily on one node.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher