user manual

18-4
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F304 Repair an IP Tunnel
DLP-F304 Repair an IP Tunnel
Step 1 Obtain the original IP address of the node in question.
Step 2 From the View menu, choose Go to Network View.
Step 3 From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 4 Review the text in the IP Repair wizard and click Next.
Step 5 In the Node IP address area, complete the following:
• Node—Choose the node that has a PARTIAL circuit.
• Old IP Address—Type the node’s original IP address.
Step 6 Click Next.
Step 7 Click Finish.
Step 8 Return to your originating procedure (NTP).
DLP-F305 Provision Path Trace on Circuit Source and Destination Ports
Note This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
at the circuit source and destination.
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Step 3 For the VC circuit you want to monitor, verify that the source and destination ports are on a card that can
transmit and receive the path trace string. Table 18-1 provides a list of cards that support path trace.
Purpose This task repairs circuits that are in the PARTIAL status as a result of node
IP address changes.
Tools/Equipment None
Prerequisite Procedures See Chapter 6, “Create Circuits.” for circuit creation procedures.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates a path trace on VC circuit source ports and destination.
Tools/Equipment ONS 15600 SDH cards capable of transmitting and receiving path trace
must be installed at the circuit source and destination ports. See Table 18-1
for a list of cards.
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher