user manual

18-38

Cisco ONS 15600 SDH Procedure Guide, R8.0

October 2007

Chapter 18 DLPs F300 to F399

DLP- F338 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard

Figure 18-10 Ethernet Ether Ports History on the Card View Performance Window

Step 3

Click Refresh. Performance monitoring statistics for each port on the card appear.

Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the

Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the

Cisco ONS 15600 SDH Reference Manual.

Note To refresh, reset, or clear PM counts, see the NTP-F184 Change the PM Display, page 8-2.

Step 5 Return to your originating procedure (NTP).

DLP-F338 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard

159561

Ethernet tab

Performance tab

History tab

Card View

Interval

Port

Help

button

Refresh

button

unlocked-disabled, auto

Purpose This task creates a two-fiber multiplex section-shared protection ring

(MS-SPRing) at each MS-SPRing-provisioned node using the CTC

MS-SPRing wizard. The MS-SPRing wizard checks to see that each node

is ready for MS-SPRing provisioning, then provisions all the nodes at one

time.

Tools/Equipment None

Prerequisite Procedures DLP-F293 Delete Circuits, page 17-81

DLP-F181 Log into CTC, page 16-34

Required/As Needed As needed