user manual

18-26

Cisco ONS 15600 SDH Procedure Guide, R8.0

October 2007

Chapter 18 DLPs F300 to F399

DLP- F327 View ASAP Ether Ports Statistics PM Parameters

Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.

Step 2 Click the Performance > Ethernet > Ether Ports > Statistics tabs (Figure 18-4).

Figure 18-4 Ether Ports Statistics in the Card View Performance Window

Step 3 Click Refresh. Performance monitoring statistics appear for each port on the card.

Step 4 View the PM parameter names appear in the Param column. The current PM parameter values appear in

the Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the

Cisco ONS 15600 SDH Reference Manual.

Note To refresh, reset, or clear PM counts, see the “NTP-F184 Change the PM Display” procedure on

page 8-2.

Step 5 Return to your originating procedure (NTP).

159544

Ethernet tab

Performance tab

Statistics tab

Card View

Help

button

Clear

button

Baseline

button

Refresh

button

Auto-refresh