user manual

18-21
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F323 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX)
Caution Deleting a DCC termination can cause you to lose visibility of nodes that do not have other DCCs or
network connections to the CTC computer.
Step 1 Click the Provisioning > Comm Channel > MS-DCC tabs.
Step 2 Click the MS-DCC termination to be deleted and click Delete. The Delete MS-DCC Termination dialog
box appears.
Step 3 Click Yes in the confirmation dialog box. Confirm that the changes appear; if not, repeat the task.
Step 4 Return to your originating procedure (NTP).
DLP-F323 Use the Reinitialization Tool to Clear the Database and Upload
Software (UNIX)
Note Restoring a node to the factory configuration deletes all cross-connects on the node.
Step 1 Insert the Cisco ONS 15600 SDH System Software CD, Version 8.0, into the computer CD-ROM drive.
If the CTC Installation Wizard appears, click Cancel.
Step 2 To find the recovery tool file, go to the CISCO15600 SDH directory on the CD (usually
/cdrom/cdrom0/CISCO15600SDH).
Step 3 If you are using a file explorer, double-click the RE-INIT.jar file. If you are working with a command
line interface, run java -jar RE-INIT.jar. The NE Reinitialization window appears.
Step 4 Complete the following fields:
• GNE IP—If the node you are reinitializing is accessed through another node configured as a gateway
network element (GNE), enter the GNE IP address. If you have a direct connection to the node, leave
this field blank.
• Node IP—Enter the node name or IP address of the node that you are reinitializing.
• User ID—Enter the user ID needed to access the node.
Purpose This task reinitializes the ONS 15600 SDH using the CTC reinitialization
(reinit) tool on a UNIX computer. Reinitialization uploads a new software
package to the TSC cards, clears the node database, and restores the factory
default parameters.
Tools/Equipment Cisco ONS 15600 SDH System Software CD, Version 8.0
JRE 5.0 must be installed on the computer to log into the node at the
completion of the reinitialization. The reinitialization tool can run on
JRE 1.3.1_02, JRE 1.4.2, or JRE 5.0.
Prerequisite procedures DLP-F181 Log into CTC, page 16-34
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only