user manual

18-19
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F319 Change an RS-DCC Termination
DLP-F319 Change an RS-DCC Termination
Step 1 Click the Provisioning > Comm Channels > RS-DCC tabs.
Step 2 Click the RS-DCC that you want to change.
Step 3 Click Edit.
Step 4 In the RS-DCC Termination Editor dialog box, complete the following as necessary:
• Disable OSPF on RS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be
disabled only when the slot and port connect to third-party equipment that does not support OSPF.
• Far End is Foreign—Check this box to specify that the RS-DCC termination is a non-ONS node.
• Far End IP—If you checked the Far End is Foreign check box, type the IP address of the far-end
node or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the
far end.
Step 5 Click OK.
Step 6 Return to your originating procedure (NTP).
DLP-F320 Change an MS-DCC Termination
Step 1 Click the Provisioning > Comm Channels > MS-DCC tabs.
Step 2 Click the MS-DCC that you want to change.
Step 3 Click Edit.
Step 4 In the MS-DCC Termination Editor dialog box, complete the following as necessary:
• Disable OSPF on MS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be
disabled only when the slot and port connect to third-party equipment that does not support OSPF.
Purpose This task modifies an RS-DCC termination. You can enable or disable Open
Shortest Path First (OSPF) and enable or disable the foreign node setting.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task modifies an SDH MS-DCC termination. You can enable or
disable OSPF and enable or disable the foreign node setting.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher