user manual

18-13
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F312 Delete a Node from a Specified Login Node Group
DLP-F312 Delete a Node from a Specified Login Node Group
Step 1 From the CTC Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the Login Node Groups tab.
Step 3 Click the login node group tab containing the node you want to remove.
Step 4 Click the node you want to remove, then click Remove.
Step 5 Click OK.
Step 6 Return to your originating procedure (NTP).
DLP-F313 Change a Circuit Service State
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Circuits tab.
Step 3 Click the circuit with the state that you want to change.
Step 4 From the Tools menu, choose Circuits > Set Circuit State.
Step 5 In the Set Circuit State dialog box, choose the administrative state from the Target Circuit Admin State
drop-down list:
• Unlocked—Puts the circuit cross-connects in the Unlocked-enabled service state.
• Locked,disabled—Puts the circuit cross-connects in the Locked-enabled,disabled service state.
Traffic is not passed on the circuit.
• Unlocked,automaticInService—Puts the circuit cross-connects in the
Unlocked-disabled,automaticInService service state and suppresses alarms and conditions. When
the connections receive a valid signal, the service state automatically changes to Unlocked-enabled.
Purpose This task removes a node from a login node group.
Tools None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the service state of a circuit.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher