user manual

18-12
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F311 Remove Pass-through Connections
Step 4 Choose the JRE version.
Step 5 Click OK.
Step 6 From the File menu, choose Exit.
Step 7 In the confirmation dialog box, click Ye s.
Step 8 Return to your originating procedure (NTP).
DLP-F311 Remove Pass-through Connections
Step 1 Log into the deleted node.
Step 2 In the CTC Login dialog box, check the Disable Network Discovery check box.
Step 3 Choose None from the Additional Nodes drop-down list.
Step 4 Click the Login button.
Step 5 Click the Circuits tab. All internode circuits are shown as PARTIAL.
Step 6 Refer to the diagram or CTC printout you created in the “NTP-F215 Remove an MS-SPRing Node”
procedure on page 13-5 or the “NTP-F217 Remove an SNCP Node” procedure on page 13-10. Find the
circuits on the line cards of the removed node.
Step 7 Click the Filter button.
Step 8 Type the slot and port of a trunk card on the removed node.
Step 9 Click OK.
Step 10 In the Circuits tab, select all PARTIAL circuits that pass the filter and click the Delete button.
Note To select more than one circuit, press the Shift key and simultaneously click on all circuits to be
deleted.
Step 11 Repeat Steps 6 through 10 for the other trunk card.
Step 12 Log out of CTC.
Step 13 Return to your originating procedure (NTP).
Purpose This task removes pass-through connections from a node deleted from a
ring.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher