user manual

18-116
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F396 Clear All PM Thresholds
Step 5 Return to your originating procedure (NTP).
DLP-F396 Clear All PM Thresholds
Caution Pressing the Reset button can mask problems if used incorrectly. This button is commonly used for
testing purposes.
Step 1 In node view, double-click the card where you want to view PM thresholds. The card view appears.
Step 2 Click the Provisioning > Threshold tabs. The subtab names vary depending on the card selected.
Step 3 Click Reset to Default.
Recovery Pulse
Duration
Sets the recovery laser pulse duration, in
seconds, for the initial, recovery optical
power pulse following a laser shutdown.
Numeric. For the default values and
domains of user-provisionable card
settings, refer to the “Network
Element Defaults” appendix in the
Cisco ONS 15600 SDH Reference
Manual.
Recovery Pulse
Interval
Sets the recovery laser pulse interval, in
seconds. This is the period of time that
must past before the recover pulse is
repeated.
Numeric. For the default values and
domains of user-provisionable card
settings, refer to the “Network
Element Defaults” appendix in the
Cisco ONS 15600 SDH Reference
Manual.
Currently
Shutdown
(Display only) Displays the current status
of the laser.
Numeric. For the default values and
domains of user-provisionable card
settings, refer to the “Network
Element Defaults” appendix in the
Cisco ONS 15600 SDH Reference
Manual.
Request Laser
Restart
If checked, allows you to restart the laser
for maintenance.
Note Restarting a laser might be
traffic-affecting.
Checked or unchecked
Purpose This task clears and resets all PM thresholds to the default values.
Tools/Equipment None
Prerequisite Procedures DLP-F181 Log into CTC, page 16-34
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only
Table 18-9 STM-N Maintenance Settings (continued)
Parameter Description Options