user manual

18-110
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F392 Change Line Transmission Settings for STM-N Cards
Service State Identifies the autonomously generated
state that gives the overall condition
of the port. Service states appear in
the format: Primary State-Primary
State Qualifier, Secondary State.
• Unlocked-enabled—The port is fully
operational and performing as
provisioned.
• Unlocked-disabled,automaticInService—
The port is out-of-service, but traffic is
carried. Alarm reporting is suppressed.
The ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in the
Unlocked-disabled,automaticInService
state for the duration of the soak period.
After the soak period ends, the port
service state changes to
Unlocked-enabled.
• Locked-enabled,disabled—The port is
out-of-service and unable to carry
traffic.
• Locked-enabled,maintenance—The port
is out-of-service for maintenance. Alarm
reporting is suppressed, but traffic is
carried and loopbacks are allowed.
SyncStatusMsg Allows you to view the incoming
synchronization status message by
clicking Show.
• SETS
• STU
• G811
• G812T
• G812L
• DUS_SDH (Do not use for timing
synchronization)
Reach (ASAP card only) Provisions the
reach value.
(The options that appear in the drop-down
list depend on the card.)
• Auto Provision—Allows the system to
automatically provision the reach from
the PPM reach value on the hardware.
• SR—Short reach, up to 2 km distance
• SR-1—Up to 2 km distance
• IR-1—Intermediate reach, up to 15 km
distance
• IR-2—Up to 40 km distance
• LR-1—Long reach, up to 40 km
distance)
• LR-2—Up to 80 km distance
• LR-3—Up to 80 km distance
Table 18-6 STM-N Card Line Settings (continued)
Heading Description Options