user manual

18-109
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F392 Change Line Transmission Settings for STM-N Cards
Admin State Sets the port service state unless
network conditions prevent the
change.
• Unlocked—Puts the port in service. The
port service state changes to
Unlocked-enabled.
• Unlocked,automaticInService—Puts the
port in automatic in-service. The port
service state changes to
Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port
from service and disables it. The port
service state changes to
Locked-enabled,disabled.
• Locked,maintenance—Removes the port
from service for maintenance. The port
service state changes to
Locked-enabled,maintenance.
Note CTC will not allow you to change a
port service state from
Unlocked-enabled to
Locked-enabled,disabled. You must
first change a port to the
Locked-enabled,maintenance service
state before putting it in the
Locked-enabled,disabled service
state.
AINS Soak Sets the automatic in-service soak
period.
Duration of valid input signal, in hh.mm
format, after which the card becomes
Unlocked-enabled automatically (0 to 48
hours, in 15-minute increments).
SyncMsgIn Enables synchronization status
messages (S1 byte), which allow the
node to choose the best timing source.
• Yes (checked; default)
• No (unchecked)
Port Rate (ASAP card only.) Displays the port
rate set for the PPM.
• STM-1
• STM-4
• STM-16
• STM-64
• Ether
Type Defines the port as SDH or SONET.
Sync Msg In and Send Do Not Use
must be disabled before the port can
be set to SONET.
• SDH (default)
• SONET
Table 18-6 STM-N Card Line Settings (continued)
Heading Description Options