user manual

18-101
Cisco ONS 15600 SDH Procedure Guide, R8.0
October 2007
Chapter 18 DLPs F300 to F399
DLP- F388 Remove an SFP/XFP
Step 2 If you are installing an SFP, orient the SFP so that the Cisco serial number label is facing away from the
shelf (to the right). If you are installing an XFP, orient the XFP to the left.
Step 3 Unlatch the bail clasp before inserting it into the slot.
Step 4 Slide the SFP or XFP into the slot on the 1PIO or 4PIO (as appropriate) and move the bail clasp to secure
the SFP or XFP.
Caution Do not remove the protective caps until you are ready to attach the network fiber-optic cable.
Note Multirate SFPs must be provisioned in CTC; single-rate PPMs do not need to be provisioned. As
needed, complete the “DLP-F358 Provision a Multirate PPM” task on page 18-70.
Step 5 Return to your originating procedure (NTP).
DLP-F388 Remove an SFP/XFP
Step 1 Disconnect the network fiber cable from the SFP/XFP.
Step 2 Release the SFP/XFP from the 1PIO or 4PIO slot by unlatching the bail clasp and swinging it to the left.
Step 3 Slide the SFP/XFP out of the slot.
Step 4 As needed, complete the “DLP-F360 Delete a PPM” task on page 18-72 to delete an SFP/XFP (PPM)
from CTC.
Step 5 Return to your originating procedure (NTP).
Purpose This task removes an XFP from a 1PIO module and removes an SFP from
a 4PIO module on the ASAP card.
Tools/Equipment None
Prerequisite Procedures DLP-F384 Install the ASAP 1PIO and 4PIO (PIM) Modules, page 18-95
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher