user manual

Chapter 5 Network Element Management
Chassis Layer2/Layer3 Management Window
5-4
Cisco 7600 Router Manager User Guide
OL-6563-01
Layer 2 Configuration
The Layer 2 Configuration area provides the following information:
• CDP—Displays the Cisco Discovery Protocol (CDP) global status on the
network element, enabled or disabled.
• UDLP—Displays the UniDirectional Link Detection Protocol (UDLP) global
status on the network element: enabled, aggressive, or disabled. The
“aggressive” option is not applicable for CatOS.
• 802.1x—Displays the 802.1x Port Based Authentication global status on the
network element, enabled or disabled.
Note Dot1x cannot be enabled if dynamic mode is enabled on one or more
ports.
Layer 3 Configuration
The Layer 3 Configuration area provides the following information:
• IP CEF—Displays the status of the IP CEF routing on the network element,
enabled or disabled. This feature cannot be disabled on Cisco 3950, 4000,
4500, 6000, 6500, and 7600 series devices.
• IP Multicast—Displays the status of the IP Multicast routing on the network
element, enabled or disabled.