user manual

5-6

Cisco Physical Access Gateway User Guide

OL-20932-02

Chapter 5 Connecting a Cisco Output Module

Installing the Cisco Output Module

Install a Cisco Output Module is provide additional output connections for a Cisco Reader Module or

Gateway

Before You Begin

Verify the following:

• Verify that the module has access to a power source. See the “Power Options and Requirements”

section on page 1-12 for more information.

• Verify that you have the necessary mounting brackets or other hardware. See the “Mounting a

Gateway or Optional Module” section on page 1-14.

Procedure

To install the module, perform the following procedure:

Step 1 Mount the module to a wall. See the “Mounting a Gateway or Optional Module” section on page 1-14

for more information.

Step 2 Connect the module to the DC power source:

a. Insert a two-pin connector plug into the DC power port (Figure 5-5)

b. Connect the Voltage In (VIN) and ground (GND) wires.

See the “Power Options and Requirements” section on page 1-12 for more information.