user manual

3-10

Cisco Physical Access Gateway User Guide

OL-20932-02

Chapter 3 Connecting a Cisco Reader Module

Installing the Cisco Reader Module

Step 5 Connect input devices to the module:

a. Insert two-pin connector plugs into the input ports (Figure 3-10).

b. (Optional, for supervised input connections only). Install two End-Of-Line (EOL) 1K termination

resistors in each supervised input interface (one terminator in each connector). Figure 3-9 shows the

terminator installation for a Normally Closed (NC) and Normally Open (NO) input connection.

Figure 3-9 Input Connections: Cisco Physical Access Gateway and Reader Module

Connect the wires from the input devices (Figure 3-10).

Note Each of the input connections can be configured as supervised or unsupervised. The tamper and

power fail inputs can be configured as additional unsupervised ports. A supervised input

supports four states: normal, alarm, open and short. An unsupervised input indicates only normal

or alarm.

RED Output RED (brown) ----------

GRN (orange)

BPR Output

(Beeper)

BPR (yellow) ---------- ----------

HCRD Hold

Control

HCRD (blue) ---------- D1/CLCK (white)

CP Card

Present

CP (purple) ---------- D0 (green)

1. Wire colors are shown in parentheses.

2. Outputs show the LED color and reader wire color (in parentheses). For example, “GRN (orange)” supports a green LED.

Attach the orange wire from the reader device.

3. ---------- means the wire slot is not used.

Chassis

Label Description

One Reader

10 Wire Connection

First Reader in a

5 Wire Connection

Second Reader in a

5 Wire Connection

1K,, 1%

187838