user manual

17-9
Cisco ASDM User Guide
OL-16647-01
Chapter 17 Configuring Logging
Event Lists
• All—All event classes
• auth—User Authentication
• bridge—Transparent firewall
• ca—PKI Certification Authority
• config—Command Interface
• ha—Failover
• ips—Intrusion Protection Service
• ip—IP Stack
• np—Network Processor
• ospf—OSPF Routing
• rip—RIP Routing
• rm—Resource Manager
• session—User Session
• snmp—SNMP
• sys—System
Step 5 Choose the severity level from the drop-down list. Severity levels include the following:
• Emergency (level 0, system unusable)
• Alert (level 1, immediate action needed)
• Critical (level 2, critical condition)
• Error (level 3, error condition)
• Warning (level 4, warning condition)
• Notification (level 5, normal but significant condition)
• Informational (level 6, informational message only)
• Debugging (level 7, appears during debugging only)
Step 6 Click OK to close this dialog box.
Step 7 In the Message ID Filters area, click Add to display the Add Syslog Message ID Filter dialog box.
Step 8 In the Message IDs field, enter a syslog message ID or range of IDs (for example, 101001-199012) to
include in the filter.
Step 9 Click OK to close this dialog box.
The event of interest appears in the list. To change this entry, click Edit.
Modes
The following table shows the modes in which this feature is available: