user manual

4-20
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Figure 4-11 AP Radio Service Sets Page
Step 5
Verify that the SSIDs you created appear in the Existing SSIDs field.
Step 6 If the VLANs and SSIDs verified in Steps 2 and 5 are correct, go to Step 7. If not, review the procedures
and correct the problem.
Step 7 In the VLAN (802.1Q) field, click Enable.
Step 8 In the Native VLAN ID field, enter 1.
Step 9 Click OK. The 802.1Q Encapsulation Mode setting changes from Disabled to Hybrid Trunk.
Your wireless network is ready to operate using the VLANs you have created.