user manual

4-19
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Enabling VLAN (802.1Q) Tagging and Identifying the Native VLAN
When you have finished creating and configuring the VLANs and their associated SSIDs, you must
enable VLAN IEEE 802.1Q tagging to make them operational. You must also identify the native VLAN.
Follow these steps to enable VLAN IEEE 802.1Q tagging and identify the native VLAN.
Step 1 Browse to the Summary Status page and click VLAN in the Associations section. The VLAN Setup page
appears (Figure 4-10).
Figure 4-10 VLAN Setup Page
Step 2
Verify that the VLANs you created appear in the Existing VLANs field.
Step 3 Click Cancel to return to the Setup page.
Step 4 Click Service Sets for the radio you are configuring. The AP Radio Service Sets page appears
(Figure 4-11).
Note Figure 4-11 shows a typical AP Radio Service Sets page. Your page may differ slightly.