user manual

4-18
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 4 Configuring VLANs
A Wireless VLAN Deployment Example
Step 4 Make the following changes to this page:
a. Rename the Primary SSID to Guest VLAN
b. Maximum under of Associations: 0
c. Default VLAN ID: [1] Native VLAN
Note Associating the Default VLAN ID to the native VLAN field is known as mapping the VLAN to
the SSID. The mapping process is how the access point is able to “connect” to the VLAN on the
switch.
d. Classify Workgroup Bridges as Network Infrastructure: yes
e. Accept Authentication Type: Shared and Network EAP
f. Default Unicast Address Filter: Allowed for each authentication type
Step 5 Click OK. The AP Radio Service Sets page appears.
Step 6 In the Service Set ID (SSID) field, enter full-time and click Add New. The AP Radio SSID #1 page
appears (Figure 4-11).
Step 7 Map the full-time SSID to the full-time VLAN ID by following these steps:
a. Highlight the full-time SSID in the Existing SSID window.
b. In the VLAN ID drop-down menu, select [2] full-time VLAN ID.
Step 8 Select Network-EAP authentication type and allow default unicast address filters.
Step 9 Click OK to save your settings and return to the AP Radio Service Sets page.
Step 10 In the Service Set ID (SSID) field, enter Part-Time and click Add New. The AP Radio SSID #2 page
appears.
Step 11 Map the Part-Time SSID to the [3] Part-Time VLAN ID.
Step 12 Select Network-EAP authentication type and allow default unicast address filters.
Step 13 Click OK to save your settings and return to the AP Radio Service Sets page.
Step 14 Create the Guest SSID and map it to the [4] Guest Default VLAN ID.
Step 15 Select Open authentication type and allow default unicast address filters.
Step 16 Click OK to save your settings and return to the AP Radio Service Sets page.
Step 17 Create the Maintenance SSID and map it to the [5] Maintenance Default VLAN ID.
Step 18 Select Open authentication type and Disallow default unicast address filters.
Note Selecting Disallow in this field allows the maintenance hand-held devices to use MAC
authentication.
Step 19 Click OK to save your settings and return to the AP Radio Service Sets page.