user manual

Contents
viii
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Settings on the Association Table Advanced Page 7-17
Event Notification Setup 7-19
Event Display Setup Page 7-19
Settings on the Event Display Setup Page 7-19
Event Handling Setup Page 7-21
Settings on the Event Handling Setup Page 7-23
Event Notifications Setup Page 7-24
Settings on the Event Notifications Setup Page 7-25
Should Notify-Disposition Events generate SNMP Traps? 7-25
SNMP Trap Destination 7-25
SNMP Trap Community 7-25
Should Notify-Disposition Events generate Syslog Messages? 7-25
Should Syslog Messages use the Cisco EMBLEM Format? 7-26
Syslog Destination Address 7-26
Syslog Facility Number 7-26
IEEE SNMP Traps Should Generate the Following Notifications 7-26
CHAPTER 8 Security Setup 8-1
Security Overview 8-2
Levels of Security 8-2
Encrypting Radio Signals with WEP 8-2
Additional WEP Security Features 8-3
Network Authentication Types 8-3
Combining MAC-Based, EAP, and Open Authentication 8-6
Protecting the Access Point Configuration with User Manager 8-7
Setting Up WEP 8-7
Using SNMP to Set Up WEP 8-10
Enabling Additional WEP Security Features 8-10
Enabling Message Integrity Check (MIC) 8-10
Enabling Temporal Key Integrity Protocol (TKIP) 8-12
Enabling Broadcast WEP Key Rotation 8-13
Setting Up Open or Shared Key Authentication 8-14
Setting Up EAP Authentication 8-15
Enabling EAP on the Access Point 8-15
Enabling EAP in Cisco Secure ACS 8-18
Setting a Session-Based WEP Key Timeout 8-19
Setting Up a Repeater Access Point As a LEAP Client 8-19
Setting Up MAC-Based Authentication 8-21
Enabling MAC-Based Authentication on the Access Point 8-21