user manual

3-27
Cisco Aironet 1200 Seres Access Point Software Configuration Guide
OL-2159-05
Chapter 3 Radio Configuration and Basic Settings
Ethernet Configuration
Entering Advanced Configuration Information
You use the Ethernet Advanced page to assign special configuration settings for the access point’s
Ethernet port. Figure 3-12 shows the Ethernet Advanced page.
Figure 3-12 The Ethernet Advanced Page
Follow this link path to reach the Ethernet Advanced page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Advanced in the Ethernet row under Network Ports.
Settings on the Ethernet Advanced Page
The Ethernet Advanced page contains the following settings:
• Requested Status
• Packet Forwarding
• Default Unicast and Multicast Address Filters
• Maximum Multicast Packets/Second
• Always Unblock Ethernet When STP is Disabled
• Default Unicast Address Filter
• Optimize Ethernet for
The page also displays the current status of the Ethernet port and its forwarding state. The current status
displays either up or down and can also display Error if the port is in an error condition.
The forwarding state displays the port’s current forwarding state. The state for normal operation is
Forwarding. Four other settings are possible:
• Unknown—The state cannot be determined.
• Disabled—Forwarding capabilities are disabled.