user manual

3-10
Cisco Aironet 1200 Seres Access Point Software Configuration Guide
OL-2159-05
Chapter 3 Radio Configuration and Basic Settings
Radio Configuration
LEAP Password
Use this field if the radio is set up as a repeater and authenticates to the network using LEAP. When the
radio authenticates using LEAP, the access point uses this password for authentication.
Follow the steps in the “Setting Up a Repeater Access Point” section on page 12-2 set up the radio as a
LEAP client.
Entering Radio Hardware Information
You use the AP Radio Hardware pages to assign settings related to the access point’s radio hardware.
The internal radio and the radio module both have an AP Radio Hardware page. Both pages contain
similar settings. Figure 3-5 shows the AP Radio Hardware page for the radio module.
Figure 3-5 The AP Radio Hardware Page for the Radio Module
Follow this link path to reach the AP Radio Hardware pages:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Hardware in one of the AP Radio rows under Network Ports.