user manual

3-8
Cisco Aironet 1200 Seres Access Point Software Configuration Guide
OL-2159-05
Chapter 3 Radio Configuration and Basic Settings
Radio Configuration
Entering Identity Information
Use the AP Radio Identification pages to enter basic locating and identity information for the access
point radios. The internal radio and the radio module both have an AP Radio Identity page. Both pages
contain the same settings. Figure 3-4 shows the AP Radio Identification page for the internal radio.
Figure 3-4 The AP Radio Identification Page for the Internal Radio
Follow this link path to reach the AP Radio Identification page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Identification in on eof the AP Radio rows under Network Ports.
Settings on the AP Radio Identification Page
The AP Radio Identification pages contain the following settings:
• Primary Port Settings
• Default IP Address
• Default IP Subnet Mask
• Service Set ID (SSID)
• LEAP User Name
• LEAP Password
The page also displays the access point’s MAC address, the radio serial number, the radio’s current IP
address, the radio’s current IP subnet mask, the maximum packet length that the radio can send and
receive, the radio firmware version, and the radio boot block version.