user manual

Index
IN-4
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Ethernet 13-32
locate unit by flashing LEDs 13-33
radio traffic 13-32
status 13-32
limiting distributions 10-10
link test 9-6
load balancing 3-19
locate unit by flashing LEDs 13-33
logs 13-13
M
MAC address 3-3
MAC address filters 5-6
MAC-based authentication 8-21
combining with EAP 8-25
setting up in Cisco Secure ACS 8-26
map windows 2-3
Maximum Number of Enabled VLAN IDs setting 4-3
memory, conserving 7-18
memory use diagnostics 13-24
Message Integrity Check 8-3
Messages C-1
MIB files
access point MIB
2-8
Cisco Discovery Protocol MIB 2-8
IEEE802dot11-MIB 2-8
standard MIB-II 2-8
MIC 8-10
monitored access point 12-5
multicast packets 3-18
N
name server 7-9
NAS, adding and configuring 8-18
native VLAN
creating
4-11
identifying 4-19
mapping to SSID 4-21
Native VLAN configuration 4-5
Native VLAN creating 4-11
Native VLAN ID setting 4-3
Network-EAP 8-3
network infrastructure, classify workgroup bridges
as
3-19
network map window 2-4
Network Ports page 13-5
O
OK button 2-3
optimize radio network for 3-6
Optionally allow Encrypted packets on the unencrypted
VLAN setting
4-4
P
packet tracing 13-28
parity 2-5
password reset 13-36
pings 9-6
ports, assigning to MAC addresses 9-11
power level maximum A-4 to A-5
power level setting 3-13
preamble 3-22
primary port 3-9
protocol filters
enabling filters
5-5
forward or block 5-5
list of available protocols B-1
priorities 5-5
setup 5-2
time to live setting 5-4
proxy Mobile IP 6-1
authentication server page explained 6-13
components of 6-7