user manual

C-24
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Appendix C Event Log Messages
Message Descriptions
Protocol
Warning
Unable to start SSH connection SSHD_CON_
INIT_FAILED
Reboot the access point.
Protocol
Information
Disconnect remote user from
ipAddr after exceeding max
number of login attempts
ipAddr: IP address of SSH client
SSHD_LOGIN_
FAILED
None.
Protocol
Warning
CRC compensation attack is
detected. Disconnect remote
user from ipAddr
ipAddr: IP address of SSH client
SSHD_CRC_
AT TACK
A user attacked a known
security hole in the SSH
protocol. Find and remove the
user or disable SSH.
System
Warning
BKeyRotation declared before
proper initialization
BKR_NOT_INIT Ignore this message unless it
appears after bootup. If it
appears after bootup, check the
configuration and reboot the
access point.
System
Warning
BKeyRotation declared before
initialization for VLAN vlanID.
vlanID: numeric VLAN
identifier
BKR_VLAN_
NOT_INIT
Ignore this message unless it
appears after bootup. If it
appears after bootup, check the
configuration and reboot the
access point.
System
Warning
Vlan vlanID is not Enabled.
vlanID: numeric VLAN
identifier
BKR_VLAN_
DISABLED
Ignore this message if the
VLAN rotation period has been
set to 0. If the VLAN rotation
period is set to a value higher
than 0, check the configuration
and reboot the access point.
System
Warning
Vlan vlanID Key Rotation
Interval is 0.
vlanID: numeric VLAN
identifier
BKR_KEY_
0PERIOD
Ignore this message if the
VLAN rotation period has been
set to 0. If the VLAN rotation
period is set to a value higher
than 0, check the configuration
and reboot the access point.
System
Warning
VLAN vlanID Key Index and
Count are in conflicting states.
vlanID: numeric VLAN
identifier
BKR_VLAN_
CONFLICT
Correct the VLAN
configuration and reboot the
access point.
System
Warning
No WID timer for VLAN vlanID
vlanID: numeric VLAN
identifier
BKR_VLAN_
NOWIDTIMER
Correct the VLAN
configuration and reboot the
access point.
System Fatal BKeyPrivate1ISR msgQSend
error, too many VLANs.
Rotation stopped for VLAN
vlanID.
vlanID: numeric VLAN
identifier
BKR_STOP_
SENDERR
Correct the VLAN
configuration and reboot the
access point.
Table C-1 Event Log Messages and Descriptions (continued)
Severity Event Description
EMBLEM
Mnemonic
Possible Cause or
Recommended Action