user manual

C-18
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Appendix C Event Log Messages
Message Descriptions
System Info Hot standby AP state indicates
that the monitor mode setup
failed
HSTNDBY_
MON_FAILED
Verify root access point
operaton.
System Info Hot Standby Disabled HSTNDBY_DIS_
OK
None.
System Info HotStandby Failed to enable Hot
Standby
HSTNDBY_
HSEN_FAILED
Verify the following:
Root access point operation.
Hot standby access point and
root access point configurations
match.
The root and standby access
point link test is successful.
System Info Hotstandby failed to set to the
Active AP mode
HSTNDBY_ACT
_FAILED
Verify hot standby and root
access point configurations
match and the standby access
point link test is successful.
System Info Hotstandby set to the Active AP
mode
HSTNDBY_ACT
_OK
None.
System Info HotStandby starts to monitor the
root AP
HSTNDBY_
STRT_MON
None.
System Info HotStandby stays as a client but
stopped its protection
HSTNDBY_
STOP
Start hot standby monitoring.
System Info HotStandby Turning into hot
standby mode
HSTNDBY_
TURN_ON
None.
System Info Turned command the media port
command: ON or OFF
media: Ethernet or Radio
HSTNDBY_
ONOFF
None.
System Info Failed in turning command the
media port
command: ON or OFF
media: Ethernet or Radio
HSTNDBY_
ONOFF_FAILED
Verify the following:
Root access point operation.
Hot standby access point and
root access point configurations
match.
The root and standby access
point link test is successful.
System Info Turned off radio port because a
Hot Standby AP took over
HSTNDBY_RAD
_OFF
None.
Port Info MAC-Address Authentication
accepted for Station clientAddr
clientAddr: client MAC address
MACAUTH_OK None.
Table C-1 Event Log Messages and Descriptions (continued)
Severity Event Description
EMBLEM
Mnemonic
Possible Cause or
Recommended Action