user manual

C-16
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Appendix C Event Log Messages
Message Descriptions
Port Fatal NIC MAC for device ifDescr
cannot be Enabled (error status)
ifDescr: Name of network
interface
status: network interface card
status
DEVAWC_
DISABLE
The access point radio might
have failed or it might be
misconfigured. Reset the access
point radio configuration
parameters to defaults and
reconfigure the radio
parameters. If this message
appears continuously, reload the
access point firmware.
Port Fatal Failed to start driver for port
ifDescr (errno=errno)
ifDescr: Name of network
interface
errno: error number
NET_DRV_
START_FAILED
If this message appears
continuously, reboot the access
point.
Port Fatal Failed to stop driver for port
ifDescr (errno=errno)
ifDescr: Name of network
interface
errno: error number
NET_DRV_
STOP_FAILED
If this message appears
continuously, reboot the access
point.
Any (this
alert
mappable to
any severity)
Packet from srcHost to dstHost,
802.2 DSAP pktType, length
pktLen
srcHost: network name/address
of source of packet
dstHost: network name/address
of destination of packet
pktType: 802.2 packet type
(ARP, for example)
pktLen: length of the packet, in
bytes
RCV_PCKT_
ALERT
Disable packet trace if
necessary.
Any (this
alert
mappable to
any severity)
Packet from srcHost to dstHost,
protocol pktType, length pktLen
srcHost: network name/address
of source of packet
dstHost: network name/address
of destination of packet
pktType: ethernet packet type
(ex. ARP)
pktLen: length of the packet, in
bytes
RCV_PCKT_
ALERT
Disable packet trace if
necessary.
Protocol Info Associated to Parent MAC
address of AP
PRNT_ASSOC None.
Table C-1 Event Log Messages and Descriptions (continued)
Severity Event Description
EMBLEM
Mnemonic
Possible Cause or
Recommended Action