user manual

C-15
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Appendix C Event Log Messages
Message Descriptions
Protocol
Fatal
Port ifDescr is not an 802.11
network
ifDescr: Name of network
interface
PRO80211_BIND
_ERR2
Reboot the access point.
Protocol
Fatal
Unknown port ifDescr
ifDescr: Name of network
interface
PRO80211_
PORT_UNKN
Reboot the access point.
Protocol
Fatal
Can not bind 802.11 Control to
port device
device: the network interface
device name/unit number
PRO80211_
CTRL_BIND_
ERR
Reboot the access point.
Protocol
Fatal
Inconsistent VxWorks END
control block for port ifDescr
ifDescr: Name of network
interface
PRO80211_BIND
_ERR3
Reboot the access point.
Port Fatal Card for device ifDescr cannot
be successfully configured (error
status)
ifDescr: Name of network
interface
status: radio status
DEV80211_CFG
_BAD
The access point radio might
have failed. Reload the access
point firmware.
Port Fatal Radio MAC for device ifDescr
can not be Enabled (error status)
ifDescr: Name of network
interface
status: device status number
MAC_ENABLE_
FAILED
The access point radio might
have failed. Reload the access
point firmware.
Port Fatal Radio Enable Failed with error
“Bad Authentication Type.”
Temporarily Disabling WEP
Encryption and re-Attempting
Enable. This error may indicate
tampering with the radio and/or
its encryption keys!
RADIO_EN_
ERROR
Reset the access point WEP
configuration. If this message
appears continuously, reload the
access point firmware.
Port Fatal Card for device ifDescr cannot
be successfully configured (error
status)
ifDescr: Name of network
interface
status: network interface card
status
DEVAWC_CFG_
BAD
Reset the access point radio
configuration parameters to
defaults and reconfigure the
radio parameters.
Table C-1 Event Log Messages and Descriptions (continued)
Severity Event Description
EMBLEM
Mnemonic
Possible Cause or
Recommended Action