user manual

C-14
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Appendix C Event Log Messages
Message Descriptions
System Fatal Failed to Set System IP Address
to netaddr (DB_Status=status)
netaddr: new IP address number
status: see “Statuses and
Reasons” section on page C-28
PRTR_SYSIP_
REQ_FAILED
There is an IP address conflict
on your network. Find and
correct the conflicting
addresses.
System Fatal Failed to Set System IP Address
to netaddr in Response to DHCP
Ack (DB_Status=status)
netaddr: new IP address number
status: see “Statuses and
Reasons” section on page C-28
PRTR_DHCP_
FAILED
There is an IP address conflict
on your network. Find and
correct the conflicting
addresses.
Protocol
Fatal
Cannot allocate Protocol-Type
List
PRTR_NO_LIST Reboot the access point.
Protocol
Fatal
Cannot bind Packet Router to
port device
device: the network interface
device name/unit number
PRTR_BIND_
PORT_FAILED
Reboot the access point.
Protocol
Fatal
Unknown port ifDescr
ifDescr: Name of network
interface
PRTR_BIND_
UNKNWN_
PORT
Reboot the access point.
Protocol
Fatal
Unable to add
AironetMcastAddrAll to port
ifDescr
ifDescr: Name of network
interface
PRTR_BIND_
MCAST_
FAILED
Reboot the access point.
Protocol
Fatal
Unable to add
AironetMcastAP_Only to port
ifDescr
ifDescr: Name of network
interface
PRTR_BIND_
MCASTAP_
FAILED
Reboot the access point.
Protocol
Fatal
Unable to add AironetMcastBSS
to port ifDescr
ifDescr: Name of network
interface
PRTR_BIND_
MCASTBSS_
FAILED
Reboot the access point.
Protocol
Fatal
Unable to add AironetMcastBSS
to port ifDescr
ifDescr: Name of network
interface
PRTR_BIND_
MCASTBSS_
FAILED
Reboot the access point.
Protocol
Fatal
Cannot bind 802.11
Management to port device
device: the network interface
device name/unit number
PRO80211_BIND
_ERR1
Reboot the access point.
Table C-1 Event Log Messages and Descriptions (continued)
Severity Event Description
EMBLEM
Mnemonic
Possible Cause or
Recommended Action