user manual

13-19
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 13 Diagnostics and Troubleshooting
Using Command-Line Diagnostics
• Use—number of packets forwarded
• Interface—one of four possible interfaces:
– emac0 for Ethernet
– awc0 for internal radio
– awc1 for external radio
– lo0 for internal loopback
Follow the steps in the “Entering Diagnostic Commands” section on page 13-16 to open the CLI and
enter the :vxdiag_arpshow command.
0x80 Subnet mask present
0x100 Generate new routes on use
0x200 External daemon resolves name
0x400 Generated by ARP
0x800 Manually added (static)
0x1000 Just discard packets (during updates)
0x2000 Modified by management protocol
0x4000 Protocol-specific routing flag
0x8000 Protocol-specific routing flag
Table 13-2 Flag Definitions (continued)
Flag Value Definition