user manual

13-15
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 13 Diagnostics and Troubleshooting
Using Command-Line Diagnostics
Figure 13-10 Event Log Summary Page
Click the Severity heading on the Event Log page to reach the Event Log Summary page.
Using Command-Line Diagnostics
You can view diagnostic information about your access point with diagnostic commands. Enter the
commands in the command-line interface (CLI) to display the information. You can open the CLI with
Telnet or with a terminal emulator through the access point’s serial port.
Table 13-1 lists the access point’s diagnostic commands. Click a command in the left column to go to a
description of that command’s results
.
Table 13-1 CLI Diagnostic Commands
Command Information Displayed
:eap_diag1_on Authentication progress for client devices
authenticating through the access point
:eap_diag2_on Packet contents of each authentication step for client
devices authenticating through the access point
:vxdiag_arpshow The ARP table
:vxdiag_checkstack Task stack on the access point
:vxdiag_hostshow Remote host list with IP addresses and aliases
:vxdiag_i Task list on the access point