user manual

11-4
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 11 Management System Setup
Console and Telnet Setup
Changing Settings with the Database Query Page
Follow these steps to change an access point setting from the Database Query page:
Step 1 Type the object identifier (OID) in the OID field. You can use the integer or ASCII version of the OID.
If you use the integer version of the OID, you must type the entire OID string (1.3.7.2.13.78.5.6, for
example). If you use the ASCII name, you can often use the object's name as specified in the appropriate
MIB (enableSNMP, for example). MIBs supported by the access point are listed in the “Supported MIBs”
section on page 2-8.
Step 2 Click Get. The current value for the setting appears in the Value field.
Step 3 Modify the value in the Value field.
Step 4 Click Set. The new value is set on the access point.
Note If the object is read-only, the value is not changed when you click Set.
Console and Telnet Setup
Use the Console/Telnet Setup page to configure the access point to work with a terminal emulator or
through Telnet. Figure 11-3 shows the Console/Telnet Setup page.
Figure 11-3 Console/Telnet Setup Page
Follow this link path to reach the Console/Telnet Setup page:
1. On the Summary Status page, click Setup.
2. On the Setup page, click Console/Telnet in the Services section of the page.