user manual

10-5
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 10 Managing Firmware and Configurations
Updating Firmware
Figure 10-4 Update All Firmware From File Server Page
Follow these steps to update all three firmware components from a file server:
Step 1 Click the File Server Setup link to enter the FTP settings. The FTP Setup page appears. Figure 10-5
shows the FTP Setup page.
Figure 10-5 FTP Setup Page
Step 2
Enter the FTP settings on the FTP Setup page.
a. Select FTP or TFTP from the File Transfer Protocol pull-down menu. FTP (File Transfer Protocol)
is the standard protocol that supports transfers of data between local and remote computers. TFTP
(Trivial File Transfer Protocol) is a relatively slow, low-security protocol that requires no user name
or password.
b. In the Default File Server entry field, enter the IP address of the server where the access point should
look for FTP files.
c. In the FTP Directory entry field, enter the directory on the server where FTP files are located.
d. In the FTP User Name entry field, enter the user name assigned to the FTP server. If you selected
TFTP, you can leave this field blank.