user manual

7-26
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05
Chapter 7 Configuring Other Settings
Event Notification Setup
Should Syslog Messages use the Cisco EMBLEM Format?
When this setting is enabled, the access point generates EMBLEM (Baseline Manageability
Specification) standard compliant system log messages:
ipaddress Counter: [yyyy mmm dd hh:mm:ss TimeZone +/– hh:mm]: %FACILTY- SEVERITY-MNEMONIC:
Message-text
Example without timestamp:
192.168.12.83: %APBR-6-STA_ASSOC_OK: [AP350-12] Station [TEST-LPT]000750abcd2a Associated
Example with timestamp:
192.168.85:2002 SEP 12 13:52:12 PST -08:00: %APBR-6-STA_ASSOC_OK: [AP350-12] Station
[TEST-LPT]000750abcd2a Associated
The timestamp is optional and included in the message only when the wall clock time is set on the access
point. The facility code for all messages is APBR.
Syslog Destination Address
Type the IP address or the host name of the server running Syslog.
The Network Default Syslog Destination line under the syslog destination address field lists the syslog
destination address provided by the DHCP or BOOTP server. This default syslog destination is only used
if the syslog destination address field is blank.
Syslog Facility Number
Type the Syslog Facility number for the notifications. The default setting is 16, which corresponds to the
Local0 facility code.
IEEE SNMP Traps Should Generate the Following Notifications
You can designate how the SNMP traps handles the following client events:
• Client Authentication Failure
• Client Deuthentication
• Client Disassociation
You can set the following options for each event:
• No Trap nor Event Log—the event is neither trapped nor logged
• Event Log Only—the event is generated and sent to the event log only
• IEEE Trap Only—the event is trapped and sent to an SNMP community
• Both IEEE Trap and Event Log—the event is trapped and sent to the event log